RollSeal RS-500 Manuel d'installation télécharger pdf (Page 14)

Page 14 RS-500/600 Door Part No 4801-5166 Rev 01-2015

7.5 Assembly of Parts

Arrange the horizontal member, left vertical member (left track), and right vertical member (right track) on

the floor in front of the clear opening as shown in Diagram 7C. The curtain side of the horizontal member

and each vertical member faces down.

Placement of Parts for Assembly

Lay left track, right track, and horizontal

member face down in front of the

clear opening as shown.

End of

horizontal

member

U-shaped

plate

Plate fits inside

vertical membe

Slide vertical member

over U-shaped plate.

Vertical

Member

Clear Opening

At this end of members

3/8" x 1"

Bolts & nuts

On each end of the horizontal member

is a U-shaped plate that fits inside each

vertical member. The U-shaped plate

has four bolt holes, two on the inside

and two on the outside flanges that

match bolt holes in the vertical

member. See Diagram 7C.

1. Align the vertical member

with the U-shaped metal plate

at end of horizontal member.

2. Slide the vertical member

onto the outside of the U-

shaped metal plate of the

horizontal member as shown

in A.

3. Insert bolts through bolt holes

as shown in B. Install nuts.

Tighten bolts & nuts securely.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

Pas de commentaire

RollSeal RS-500 Manuel d'installation Page 14