RollSeal RS-500 Manuel de service télécharger pdf (Page 11)

4801-5159 Rev 01-2015 Technical Installation and Service Manual Page 11

5 Controller Installation and Setup

5.1 Tools Required

Small Screwdriver Standard Screwdriver Wire Strippers

5.2 Installation Instructions

1. Unpack system, and check that all components are present.

1 RollSeal Smart Controller

1 Installation Kit

1 Manual

2. Hang the controller with four screws at the desired location.

3. Make sure all power supplies are disconnected before breaking any wires, or reaching into the

controller enclosure.

4. Determine the required Powering Voltage whether 115 VAC (SC-325 only) or 230 VAC.

5. If the desired power supply voltage is different from the factory preset/prewired voltage, the

appropriate version Brake Rectifier must be ordered separately, field-installed on the RS Door, and

the SC controller switch & jumper settings changed accordingly. The SC-325 Controllers are factory

preset to 115 VAC and the RS-500 Doors factory prewired to require a 115 VAC power supply. The

SC-650 Controllers are factory preset to 230 VAC and the RS-600 Doors factory prewired to require

a 230 VAC power supply. The SC-325 Controller can be field upgraded to accommodate either 115

VAC or 230 VAC power supply. Refer to Section 6 for the SC Controller power wiring, switch

setting, and jumper setting and Section 15 for the Motor Brake Rectifier part numbers and wiring

information.

Warning!

Only Qualified Electrical Personnel Familiar With The Construction And Operation Of This

Equipment And The Hazards Involved Should Install, Adjust, And/Or Service This Equipment.

Read And Understand This Manual In Its Entirety Before Proceeding.

Failure To Observe This Precaution Could Result In Severe Bodily Injury Or Death!

Warning!

Dangerous High Voltages!

Allow Approximately 5 Minutes For The Controller To Power-Down Before Changing Switch

Setting, Jumper Placement, Or Wiring.

6. Connect power. See Section 6.

7. Connect AC/DC Harness hook up.

8. Turn the controller on.

9. Set the Open and Closed Speed and Limits, the Acceleration and Deceleration Ranges, Close Time

Delay and Switch positions. See Section 8 and Manual No 4801-5156 for more information.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Pas de commentaire

RollSeal RS-500 Manuel de service Page 11