RollSeal RS-500 Manuel de service télécharger pdf (Page 14)

Page 14 Technical Installation and Service Manual 4801-5159 Rev 01-2015

Actual Position

Open Speed

Close Speed

TotalCycles

Service Cycles

Door Obstruction

(Cycles 100)

Mode

Up/Down Arrows

Mode

Safety Beam Obstructed

8 Door Setup Guide

The following programming adjustments are performed on the SC-325 or SC-650 Controller.

Note: DO NOT USE JOG MODE to do these tests.

1. Press and hold the ‘MODE’ Button until P1 is shown on the Display. Set P1 to 45 seconds for the ‘Time

Out’ Function.

2. Press the ‘MODE’ Button 1 time to P2. Use the ‘UP’ ‘DOWN’ Arrows to set P2 to 20.

3. Press the ‘MODE’ Button 1 time to P3. Use the ‘UP’ ‘DOWN’ Arrows to set P3 to 80.

4. Press the ‘MODE’ Button 1 time to P4. Use the ‘UP’ ‘DOWN’ Arrows to set P4 to 3.

NOTE: This must be 3 for Freezer CMS Box to heat and blow air.

5. Press the ‘MODE’ Button 1 time to P5. Set P5 to 25.

6. Press the ‘MODE’ Button 1 time to P6. Set P6 to 5.

7. Press the ‘MODE’ Button 1 time to P7. Set P7 to 25.

8. Slowly press the ‘MODE’ Button skipping P10, P11, and P12 until you see PS1 on the display. It will

indicate ‘NO’ on the screen. Press the ‘Up’ Arrow to change ‘NO’ to ‘YES’ on the display. You will now

begin to set the upper and lower limits of the door panel (fabric). Press the ‘MODE’ Button again and the

panel will move towards the HOME switch (in the door header) and then back down towards the current

setting of the OPEN Limit. Use the ‘UP’ and ‘DOWN’ Arrows to set the UPPER Limit between 20-24 on

the Display. Then press the ‘MODE’ Button again and the panel will move downwards toward the current

CLOSE Limit. Use the ‘UP’ and ‘DOWN’ Arrows to achieve the proper LOWER Limit and ensure that the

panel is resting firmly against the floor to create a good seal (especially important for Freezer Doors.). If the

door closes to the floor on the first attempt, press the ‘UP’ Arrow to bring the panel slightly off the floor and

then press the “DOWN’ Arrow to achieve this seal. This will prevent slack in the panel which could result in

the panel auto reversing when it hits the floor. The number displayed will then become your LOWER Limit.

9. Press the ‘MODE’ Button one last time to Exit Programming Mode. The LOWER Limit that was just set

will remain on the display and the Green LED on the Controller should be lit beside “ACTUAL

POSITION’.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Pas de commentaire

RollSeal RS-500 Manuel de service Page 14