RollSeal RS-500 Spécifications télécharger pdf (Page 28)

Page 28 RollSeal SC-325 & SC-650 Controllers Part No 4801-5156 Rev 10-2014

11 Accessories

11.1 Remote Transmitter and Receiver (Ordered Separately)

The Remote Receiver may be powered from the SC-325 or SC-650 PCB 154 “DC Power” connection (12

VDC). The Receiver SW1 voltage selection switch must be set to 12v and SW2 relay output must be set to

continuous (CONT). The Remote Receiver is normally wired to the PCB 154 Sequential Timed connection.

The receiver comes standard with a “F” connector and a ½ wave wire antenna. If signal conditions require the

use of an external coax antenna to eliminate signal blockage due to obstructions, dead spots, etc., use RG59

coax to extend the antenna to the remote location. The ½ wave wire antenna may be left on the receiver. The

receiver and transmitter 9-pole, 3 position coding switches can be set to any switch position as long as the

receiver coding switch and transmitter coding switch are exactly matched. Refer to Section 12.11 for

connections to the Remote Receiver.

Transmitter

Receiver

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 49 50

Pas de commentaire

RollSeal RS-500 Spécifications Page 28