RollSeal RS-500 Manuel d'utilisateur télécharger pdf (Page 3)

ENVIRONMENTAL ISSUES

Protect your environment and protect your business from

fines by handling your dirt cleaning solution according

to federal, state, and local codes. According to federal

regulations, which states have to adopt as minimum

standards, the dirty cleaning solution in a spray washer

is generally not “hazardous waste”. To be considered a

hazardous waste by the U.S. Government, the solution

has to have one more of the following four (4)

characteristics:

IGNITABILITY

A solid waste is a hazardous waste if it is a liquid and a

representative sample has a flash point less than 140F.

CORROSIVITY

A solid waste is a hazardous waste if it is an aqueous

solution and a representative sample have a pH less than

or equal to 2 or greater than or equal to 12.5.

REACTIVITY

A solid waste is a hazardous waste if a representative

sample reacts violently with water exposed to low pH

solutions.

EP TOXICITY

A solid waste is a hazardous waste if a representative

sample leaches heavy metals in concentration greater

than 100 times primary drinking standard concentrations.

The two characteristics that you have to be most

concerned about are CORROSIVITY and EP TOXICITY.

Ask your detergent supplier if the pH of your solution is

greater than 12.5 and if so, how it can be neutralized

with acid. To check for EP Toxicity, you would need to

have a sample tested by a laboratory.

Assuming that your solution is not hazardous, or that with

minor treatment (e.g., adding acid) the solution can be

made non-hazardous, the EPA does not require special

storage, documentation, transportation, and processing.

Since your solution will have oils, however, you will

probably not be able to dump the solution in the sewage

line (call your sewage treatment facility) and you

certainly can’t dump the solution on the ground or in a

storm drain. As you will read in the Maintenance Section

of this manual, you can separate the oil and solid

contaminants from the solution so that the cleaning

solution can last for an indefinite period.

SHIPPING DAMAGE

If any damage is found, notify your carrier

immediately and save all crating materials for the

carrier’s inspector to examine.

Failure to promptly report

damage could result in denial of your claim.

A trucking company’s procedure for handling damage is

as follows:

1). Immediately send out an inspector. An inspection

report is filled out on the spot, a copy of which is given to

the customer.

2). The customer has to call the carrier to request a

claim form.

3). The customer mails in the claim form.

4) The claim usually takes two (2) months to process.

NOTE:

If a unit is seriously damaged, your Ranger Products

dealer may be able to intervene, requesting that the

damaged unit be returned and a new unit delivered.

If no damage is found, remove the bolts or steel bands

which fasten the machine to the skid. The machine

may be fastened on two or all four corners. Remove the

machine from the skid being careful not to damage the

casters on the underside.

UNPACKING: Open the door and unpack small parts

and soap.

DANGER!

Do not use the unit if the door safety switch does

not stop the spray pump when the door is open.

Call for service.

CAUTION!

Handling of the machine / components must be

performed only with an appropriate lifting device

such as a forklift or shop crane. Only personnel who

are experienced and qualified on material handling

procedures should handle any

transportation or moving of machine

components.

1 2 3 4 5 6 7 8 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

RollSeal RS-500 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage RollSeal RS-500