RollSeal RS-500 Manuel d'utilisateur télécharger pdf (Page 7)

MAINTENANCE

Assign the responsibility for your parts washer to one

person to avoid abuse and neglect.

Daily:

 Check the water level, which should be inside the

fiter basket. Never allow the water level to get below

the filter basket.

 Clean any spray nozzles that are clogged.

 If any solution spilled onto the painted surfaces, wipe

it off with fresh water.

 Clean out the removable filter basket.

 Adjust the detergent concentration as needed.

 By removing the oil and sludge contamination regularly,

you can greatly prolong the life of your cleaning

solution.

 When the floating oil is between ¼” – ½” deep, or when

this oil starts to impede cleaning, skim it out of the

tank.

 Do not allow the sludge accumulation in the tank to

exceed a 1” depth. Otherwise, the sludge build-up

could damage the heating element(s) and pump.

Depending on the application, some businesses

have to clean out the sludge weekly, while others

can go months before cleaning out the tank. Since

you can’t see the sludge, clean out the tank within the

first week of operation and develop an appropriate

clean out schedule.

Monthly:

 Check all external hoses for leaks or weaknesses and

replace if necessary. Check hoses during a wash cycle

to see if a bubble forms in the hose lining.

 Check all components making sure they are in good

operating condition.

 DO NOT USE if any component is found damaged

or defective.

 Visually inspect all wiring electrical components.

 Remove sludge from the tank following the

procedures as outlined.

REMOVING SLUDGE FROM THE TANK

 Disconnect power to the machine or make sure the

pump and heat timers are off.

 Remove the work rack and filter basket.

 Using the drain on the side, remove the water above

the sludge line and save it for reuse.

 Scrape out the sludge through the filter basket

opening being careful not to hit the heating element

Open the drain if this helps you remove any of the

sludge. Put the sludge in a drum and store it as

hazardous waste.

 Replace the water content, correct the water level,

and replace all components.

 If you have a problem with clogged nozzles you may

need to flush the spray pipes. Remove any pipe caps

and bottom spray nozzles and run a brief 30-60 second

wash cycle to flush out the sediment.

DANGER!

Disconnect tag and lock out power source

before attempting to install, service, relocate

or perform any maintenance.

CAUTION!

Running a longer wash cycle with spray nozzles

removed could damage the pump motor.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

RollSeal RS-500 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage RollSeal RS-500