RollSeal RS-500 Manuel d'installation télécharger pdf (Page 22)

Page 22 RS-500/600 Series Doors Part No 4801-5154 Rev 01-2015

13.7 Infrared Sensor Connectors (Brother Motor Option Only)

Located at the bottom of each vertical member is an infrared detector. The detector on each vertical member

operates as a safety device if the infrared beam is interrupted. Door can be set to stop if beams are broken

while closing or to stop and reverse to the full open position. Refer to the RollSeal SC-325 and SC-650

Controller Manual for more information.

1. Locate female connector on vertical member. This connector is attached to the infrared detector.

2. Locate male connector on horizontal member. Unroll cable until connectors meet. Pull enough slack to

create a service loop, such that connectors can be pulled out of tracks for photo eye replacement and

troubleshooting purposes.

3. Plug connectors together. Make sure connectors interlock.

4. Repeat for both infrared detectors.

5. Cable ties and adhesive mounts are supplied to secure wire to the inside of tracks.

Diagram 13E

13.8 Fastening Door Assembly to Clear Opening

Diagram 13F

1. Use a tape measure and make sure that the overall

height and overall width of the clear opening meet

the requirements: Overall Height = Height + 20.688

in. (52.55 cm), Overall Width = Width + 16.4 in.

(41.66 cm). Reference appropriate Table 1-4, pages

11, 14, 15, and 17.

2. Make sure that door assembly is plumb & square.

See Diagram 13F.

3. Center door assembly on clear opening. Align the

bottom of each vertical member with the respective

framing board or posts of the clear opening.

NOTE: For each vertical member, unroll respective

sensor cable attached to horizontal member until

cable reaches the sensor connector attached to the

vertical member. Pull enough slack for photo eyes

replacement and troubleshooting purposes.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 62 63

Pas de commentaire

RollSeal RS-500 Manuel d'installation Page 22