RollSeal RS-500 Manuel d'installation télécharger pdf (Page 27)

Part No 4801-5154 Rev 01-2015 RS-500/600 Series Doors Page 27

16 Installation of RS-500/600 Series Doors (Freezer Kit Included)

Installation of a RS-500/600 series Automatic Freezer Door involves connecting to the Smart Controller SC-325 and

SC-650 that connects to the AC power, the door motor, the Up/Down button, and the safety beam, plus connecting

the Condensation Management System (CMS) Unit and associated duct work. Other accessories can be added such

as a remote IR sensor, a remote radio link, and door movement indicators such as lights and bells.

16.1 Tools Required

3/8 in. (10 mm) Power screwdriver (portable)

3/16 in. (5 mm) Drill bit and power drill

3/8 x 1 in. Bolts and nuts (supplied)

Socket

Hammer

Tape measure

Carpenter's level

NOTE: Other Tools May Be Required According To Installation.

16.2 Overview

The RS-500/600 Freezer Door is shipped with pre-assembled vertical members (left track and right tracks),

with floating magnets, and a pre-assembled horizontal member (head unit). Identify components by the

Parts/Assemblies section in back of this manual. When components are received, check for damaged, loose or

missing parts. If there are damaged or missing parts contact your RollSeal distributor immediately. Please

read and understand all instructions in this manual before beginning installation. After the door has been

assembled and attached to the door framing per instructions in Section 13, Page 18 of this manual it is

necessary to install the Condensation Management System (CMS) and ducts to complete the freezer door

installation.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 62 63

Pas de commentaire

RollSeal RS-500 Manuel d'installation Page 27