Part No 4801-5154 Rev 01-2015 RS-500/600 Series Doors Page 43
27.3 Wiring Options to the Manaras Operator Terminal Block
Radio Controls: Consists of a radio receiver unit and remote transmitters. These controls consist of
an RF signal being emitted on a "pulse" basis to a mated receiver tuned to the same "pulse" rate.
Once the receiver accepts the code, a relay is activated closing a set of contacts.
Photo-electric units: Can be used as opening and reversing devices. An infrared light is emitted from
the control to a reflector and back. If, during closing travel of the door, the light beam is broken, the
door will reverse to the fully open position.
Digital Keypad: Consists of a control head which is pedestal mounted. Similar to a telephone touch
pad it allows the selective coding of a four number series. Once the programmed series of numbers is
received in their set order, a relay closes and completes a circuit.
Card Reader: A magnetic-mechanical device which accepts sealed and coded cards. The cards
trigger magnets to rise in the cartridge head, releasing a lock mechanism which allows a deeper
insertion of the card. The card then contacts a switch that closes the circuit.
Key Switch: Momentary contact will open door. Can be wall or post mounted for interior or exterior
use. * Refer to Diagram 27C, Manaras Terminal Input Connections.
Manaras Terminal Input Connections
NOTE: Certain accessory devices may require additional power wiring.
1LN98765432
Line Neutral
THREE PUSH BUTTON
OPEN
CLOSE
STOP
RADIO RECEIVER
PUSH BUTTON
(OPEN/CLOSE COMMAND)
PHOTO CELL
EXTERNAL
INTERLOCK
DIGITAL KEYPAD
KEY STATION
(OPEN COMMAND)
CARD READER
(OPEN COMMAND)
24 VAC PILOT LIGHT
to indicate “POWER ON”
24 VAC
POWER
STOP
COM
OPEN
CLOSE
SAFETY
DEVICE
COM
OPEN /
CLOSE
24 VAC
Ground
PU
H-BUTT
N
TATI
N
Commentaires sur ces manuels