RollSeal RS-500 Manuel d'installation télécharger pdf (Page 23)

Part No 4801-5154 Rev 01-2015 RS-500/600 Series Doors Page 23

NOTE: The vertical members should

be aligned so that their outer

flanges will exactly overlap

with the framing boards or

posts when the door

assembly is raised into

position.

4. Assemble workers and

equipment into position on

each side of the door assembly.

IMPORTANT: SLOWLY LIFT TOP

OF DOOR ASSEMBLY TO

RAISE THE DOOR. See

Diagram 13G.

Diagram 13H

5. Lean door assembly upright against clear opening.

6. Carefully press flanges of the door assembly flush against faces of framing boards or posts.

7. Fasten Tek screws (in steel) or lag screws (in wood) through the flanges on sides of door assembly.

Securely tighten all screws.

8. On the lower and upper flanges of the horizontal member there are attachment points for fastening

screws. Fasten Tek screws (in steel) or lag screws (in wood) through the holes. This secures the top of

the door to the clear opening.

9. Locate the two floor mounting holes at the bottom of the left and right tracks. See Diagram 13H.

10. Drill a 1/4" hole and install Hammer Set Anchors (1002-6030) in both right and left tracks. See

Diagram 13H.

11. This completes fastening of the door assembly to the clear opening.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 62 63

Pas de commentaire

RollSeal RS-500 Manuel d'installation Page 23